Rear springs

[Howard Wright]

Hi Duncan

I'm not too sure but I think that the backplates look to be Morris so it is possibly unlikely that there will be a hole drilled to aid the drifting out of the spring pin.  The grub screw looks to be the securing mechanism for the pin although I'm not sure I would like to rely on this to hold the pin.  I doubt that there will be a cotter but you need to find out.

I think your best bet is to strip away the shocker undo the grub screw, check that there is no cotter or other holding device and use a puller to get the pin out.

Good luck!

Cheers

Howard