01-08-2019, 10:08 PM
Please find pictures of seats recently recovered.
Original seat base was a 13mm board on to which was mounted a 3 inch foam base and vinyl cover.
This was mounted to the floor again 13mm board.
To sit as low as possible I mounted a 2inch horsehair base to a 6mm board, removed a section of 13mm flooring and replaced with 3mm steel plate.
Not sure how I can lower any further?
The seat back since also being recovered my need slight modification to allow it to sit approx 1inch further back.
Driving position is comfortable apart from throttle pedal being to high causing my right knee to rub on the steering wheel, being 6ft tall probably doesn't help!
Original seat base was a 13mm board on to which was mounted a 3 inch foam base and vinyl cover.
This was mounted to the floor again 13mm board.
To sit as low as possible I mounted a 2inch horsehair base to a 6mm board, removed a section of 13mm flooring and replaced with 3mm steel plate.
Not sure how I can lower any further?
The seat back since also being recovered my need slight modification to allow it to sit approx 1inch further back.
Driving position is comfortable apart from throttle pedal being to high causing my right knee to rub on the steering wheel, being 6ft tall probably doesn't help!