14-07-2019, 11:09 PM
Alan,
Thanks for your reply unfortunately my working engine in the car is in running order so I cannot measure the piston height so not sure where my starting point is.
I just hoped someone might know piston to block top face measurement.
As I do not know the shim thickness of the ones supplied I was not sure how much metal to remove, I took as little as possible off to clear the damaged part, with two joints and a spacer the block may be too high now.
Ruairidh,
Thanks I knew they were available but not what thickness they were, so that I knew how much to machine off without then being too high.
Roger
Thanks for your reply unfortunately my working engine in the car is in running order so I cannot measure the piston height so not sure where my starting point is.
I just hoped someone might know piston to block top face measurement.
As I do not know the shim thickness of the ones supplied I was not sure how much metal to remove, I took as little as possible off to clear the damaged part, with two joints and a spacer the block may be too high now.
Ruairidh,
Thanks I knew they were available but not what thickness they were, so that I knew how much to machine off without then being too high.
Roger
Location:- Haverfordwest, Pembrokeshire.