26-05-2019, 10:56 PM
(This post was last modified: 26-05-2019, 10:59 PM by dickie65.
Edit Reason: Addition.
)
Hi,
If your front axle is a replica bowed sports one it is likely that it has been shortened in the bending process.
Track can be reduced by 1 1/2" over the factory sports front axle.
The result is that the track rod has to be shortened by cutting the threaded ends down which is how it appears in your pictures.
Plus gas / patience / and heat will be needed. ( go carefully on the heat Plus Gas burns very well )
You can always pull the kingpins and put the whole lot on the workbench.
If your front axle is a replica bowed sports one it is likely that it has been shortened in the bending process.
Track can be reduced by 1 1/2" over the factory sports front axle.
The result is that the track rod has to be shortened by cutting the threaded ends down which is how it appears in your pictures.
Plus gas / patience / and heat will be needed. ( go carefully on the heat Plus Gas burns very well )
You can always pull the kingpins and put the whole lot on the workbench.