23-05-2019, 10:36 PM
Simon,
Half shaft pinions rubbing on diff casing because ground too far up tapers?
I am sure that I checked for this on reassembly and it was ok.
Starter pinion not disengaged?
This would be heard even when car stationary and engine running, but all is quiet then.
Gear cluster moved in 'box so two gears touching that shouldn't be?
Not sure about this one but would it be there on all four gears or just two from same shaft?
The last one, not too sure how this one works.
From all the replies so far I have lots to do over the weekend.
Thanks again all for the answers.
Roger
Half shaft pinions rubbing on diff casing because ground too far up tapers?
I am sure that I checked for this on reassembly and it was ok.
Starter pinion not disengaged?
This would be heard even when car stationary and engine running, but all is quiet then.
Gear cluster moved in 'box so two gears touching that shouldn't be?
Not sure about this one but would it be there on all four gears or just two from same shaft?
The last one, not too sure how this one works.
From all the replies so far I have lots to do over the weekend.
Thanks again all for the answers.
Roger
Location:- Haverfordwest, Pembrokeshire.