14-05-2019, 06:48 PM
The steering column on my special is from a Mk 11 Ruby and I wish to remove, and discard, the horn push and indicator arrangement at the steering wheel end so that I can make a plain centre cap.
I know that to do so I must release the clamp from the bottom and pull the tube and wiring out complete but in doing so will I then allow the steering box oil to escape or is there some other form of seal at the bottom please?
If this is not the case and I then have an open end to the steering box, could anyone suggest an alternative method of retaining the oil please?
Many thanks for your time.
Graham.
I know that to do so I must release the clamp from the bottom and pull the tube and wiring out complete but in doing so will I then allow the steering box oil to escape or is there some other form of seal at the bottom please?
If this is not the case and I then have an open end to the steering box, could anyone suggest an alternative method of retaining the oil please?
Many thanks for your time.
Graham.