07-05-2019, 12:36 PM
Hi guys,
I know this has been covered many times before but I'm stuck, the carb drips after switching off and even sometimes comes out of the 2 pin holes on top of the float chamber when running or just switched off.
I have replaced the needle valve and tried every combination of washer supplied with the needle.
Replaced the emulsion gasket (is sealant needed)
Tried a different float, and 2 gaskets behind the fuel pump(which is new ) It still drips
Any other suggestions gratefully received
(would it matter if the replacement needle valve from Burlens is longer in length ?)
I know this has been covered many times before but I'm stuck, the carb drips after switching off and even sometimes comes out of the 2 pin holes on top of the float chamber when running or just switched off.
I have replaced the needle valve and tried every combination of washer supplied with the needle.
Replaced the emulsion gasket (is sealant needed)
Tried a different float, and 2 gaskets behind the fuel pump(which is new ) It still drips
Any other suggestions gratefully received
(would it matter if the replacement needle valve from Burlens is longer in length ?)