02-05-2019, 03:34 PM
(This post was last modified: 02-05-2019, 03:41 PM by Steve Jones.)
Assume this is for Adam's car, Mark. The problem with finding an off the shelf manifold is that it's a special and therefore the manifold will have to be a one off. Ulster pattern manifolds are available from Tony Betts but you'd need to try one against the car to see if it would fit.
This is my new manifold that was made as a one off by Ryan Edwards at Bicester Heritage. Whilst he would normally need the car, I was able to supply the old manifold that he was able to use as a template. He also had the inlet manifold and carburettor so that we could be sure they fitted and the linkages had sufficient clearance.
20190222_152256.jpg (Size: 18.88 KB / Downloads: 254)
Steve
This is my new manifold that was made as a one off by Ryan Edwards at Bicester Heritage. Whilst he would normally need the car, I was able to supply the old manifold that he was able to use as a template. He also had the inlet manifold and carburettor so that we could be sure they fitted and the linkages had sufficient clearance.
20190222_152256.jpg (Size: 18.88 KB / Downloads: 254)
Steve