02-04-2019, 04:05 PM
I usually put a bolt or 5/16" stud through the radial hole in the flywheel periphery. As you turn the nut the stud rests against the top of the housing.
Robert Leigh
Robert Leigh
|
Flywheel locking tool
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flywheel locking tool - by John Mason - 02-04-2019, 03:57 PM
RE: Flywheel locking tool - by Robert Leigh - 02-04-2019, 04:05 PM
RE: Flywheel locking tool - by Ruairidh Dunford - 02-04-2019, 04:09 PM
RE: Flywheel locking tool - by dickie65 - 02-04-2019, 09:07 PM
RE: Flywheel locking tool - by John Mason - 02-04-2019, 09:37 PM
RE: Flywheel locking tool - by Charles P - 02-04-2019, 10:20 PM
RE: Flywheel locking tool - by dickie65 - 02-04-2019, 10:34 PM
RE: Flywheel locking tool - by Dennis Nicholas - 02-04-2019, 11:37 PM
RE: Flywheel locking tool - by Mick Hanna - 03-04-2019, 01:38 PM
RE: Flywheel locking tool - by Steve Jones - 03-04-2019, 02:02 PM
RE: Flywheel locking tool - by Chris KC - 03-04-2019, 04:26 PM
RE: Flywheel locking tool - by John Mason - 03-04-2019, 06:25 PM
RE: Flywheel locking tool - by Colin Reed - 03-04-2019, 08:48 PM
RE: Flywheel locking tool - by Mick Hanna - 04-04-2019, 11:15 AM
|
Users browsing this thread: 4 Guest(s)