01-04-2019, 06:19 PM
Sorry to start another thread relating to charging.
I have converted my dynamo to 2 brush operation and used a 12v DVR regulator.
As I only had 1.5 ohms field coil resistance I fitted a 1 ohm resistor .
The dynamo is charging well , probably too much. The resistor is 10 watt and gets hot
I am told I need to get the field coils rewound ,and that they should show a total resistance of 6 ohms.
I have seen advertised somewhere new field coils for £95 but can't remember where.
Anyone had their field coils rewound latey?
Before anyone suggest, I don't want to go down the Acuspark route.
Thanks in advance
I have converted my dynamo to 2 brush operation and used a 12v DVR regulator.
As I only had 1.5 ohms field coil resistance I fitted a 1 ohm resistor .
The dynamo is charging well , probably too much. The resistor is 10 watt and gets hot
I am told I need to get the field coils rewound ,and that they should show a total resistance of 6 ohms.
I have seen advertised somewhere new field coils for £95 but can't remember where.
Anyone had their field coils rewound latey?
Before anyone suggest, I don't want to go down the Acuspark route.
Thanks in advance