12-02-2019, 06:07 PM
I had this problem a while back, after completely dismantling the motor. I think the trouble is with the gear at bottom left in the attached photo. On the other end is the slot into which the pin on the shaft engages for 'drive' and if its reassembled in the wrong position it will cause the 'park' to be misaligned.
The solution, unfortunately, is to take the plate off which covers the gear assembly, push the gear out so that it disengages from the strangely-shaped drive plate above, and realign it so that the shot matches the required park position, then reassemble...
As Ruairdh says, don't take my word for it, but I'm pretty sure this is your problem - good luck!
Alastair
The solution, unfortunately, is to take the plate off which covers the gear assembly, push the gear out so that it disengages from the strangely-shaped drive plate above, and realign it so that the shot matches the required park position, then reassemble...
As Ruairdh says, don't take my word for it, but I'm pretty sure this is your problem - good luck!
Alastair