12-02-2019, 04:46 PM
I believe there is a peg in the spindle that engages with a slot in the drive. This fixes the arc that the blade wipes. The angle of the hook in the end that engages in the knob to park the blade fixes the park position.
This implies that the shaft needs to be twisted close to the hooked end. This should be done with the blade adjusted on the spindle to give the correct wipe pattern. Then the shaft twisted so that the hook engages in the knob with the blade in the park position.
This implies that the shaft needs to be twisted close to the hooked end. This should be done with the blade adjusted on the spindle to give the correct wipe pattern. Then the shaft twisted so that the hook engages in the knob with the blade in the park position.
Jim