11-02-2019, 11:57 PM
I think I see a solution on the outside where the arm is.
Its a Nut.
You should be able to set the wiper in the park position, loosen the Nut which locks the arm onto the spindle with a collet.
Then rotate the arm to the desired position then re tighten the Nut.
Experiment with the Collet nut just allowing the arm to slip to get the best coverage.
Do not expect the arm to park out of the way, you will have to manually park the arm to manage this.
There were a lot of adjustable length arms for these wipers, you might need to try a six inch blade as well.
Best of Luck
Its a Nut.
You should be able to set the wiper in the park position, loosen the Nut which locks the arm onto the spindle with a collet.
Then rotate the arm to the desired position then re tighten the Nut.
Experiment with the Collet nut just allowing the arm to slip to get the best coverage.
Do not expect the arm to park out of the way, you will have to manually park the arm to manage this.
There were a lot of adjustable length arms for these wipers, you might need to try a six inch blade as well.
Best of Luck