30-01-2019, 06:44 PM
The one's I fitted recently from A7c just pressed in.
I have made up a tool to fit them from PVC just a spigot on a piece of round bar a few thou less than OD,square them up and tap in.
I also put a smear of grease on the lip and check half shafts for damage,use a stone to clean any marks on assembly.
Andy
I have made up a tool to fit them from PVC just a spigot on a piece of round bar a few thou less than OD,square them up and tap in.
I also put a smear of grease on the lip and check half shafts for damage,use a stone to clean any marks on assembly.
Andy