29-01-2019, 11:08 PM
(29-01-2019, 08:27 PM)Colin Wilks Wrote: Resurrecting this thread to ask if people can identify the linings I have here. Car is a '34 Type 65 with 4 speed syncro box. Clutch linings are riveted to flywheel and pressure plate. There's less than 1 mm above the rivets so I intend renewing them whilst I've got everything apart. Are these Borg & Beck or Newton Bennett?
Second question: The plate has rotated axially against it's central boss, which I assume means that it'll be the rivets that have worn as I think they're softer than the plate. "Clutch Boss Rivets" are available from our cherished suppliers at minimal cost, but how do you go about fitting them?
Neither.They look like the ones sold by Seven Workshop, from the photo I would say they dont warrant replacement, but then They are quite cheap to replace while the engin is out.