16-01-2019, 06:33 PM
Just a reminder for bearings:- the moving race is usually an easy push fit while the static race is tighter fit......in the case of the hub - outer is moving so easy push fit in hub and felt carrier; whilst inner is static so a harder fit on the axle (also in this case is held by a locking nut.
If you use a bearing with seals either side, the seals can be prised off to clean out dried up/dirty grease and re-grease, they can then be pushed back in place.
Dennis
If you use a bearing with seals either side, the seals can be prised off to clean out dried up/dirty grease and re-grease, they can then be pushed back in place.
Dennis