09-12-2018, 01:19 PM
To 'straighten the motor shaft, you will need a press. Support the armature with 2 'V' blocks, one at the commutator end close to the commutator, and the other at the "bendix" end as near to the end as practical. A third large "V" block should go between the press ram and the armature windings at the bendix end.
A motor shaft is easily bent if the engine is seized / hydraulically locked due to a head gasket water leak - How do I know that !!
A motor shaft is easily bent if the engine is seized / hydraulically locked due to a head gasket water leak - How do I know that !!