14-11-2018, 11:19 AM
Hi Simon this is not a problem you find this with most of these bushes, check for any machining burrs polish out the bore of the 1st motion
shaft and the outer side of the bush the fit is not critical it just has to freely slide on both surfaces. If you as fitting a set of c/ratio
gears you usually find the bore of the 1st motion shaft has shrunk and needs polishing out with a small emery drum.Parting the
layshaft depends on the fit some you can knock apart with a shouldered brass punch or you may need to press it apart.
Terry.
shaft and the outer side of the bush the fit is not critical it just has to freely slide on both surfaces. If you as fitting a set of c/ratio
gears you usually find the bore of the 1st motion shaft has shrunk and needs polishing out with a small emery drum.Parting the
layshaft depends on the fit some you can knock apart with a shouldered brass punch or you may need to press it apart.
Terry.