03-11-2018, 01:48 PM
I am stripping my Zenith 30VEI and the pin which provides the pivot for the lever connecting the strangler lever to the throttle via a rod is very badly worn, so I want to replace it.
I am assuming it is a straight press fit item so intend cutting it off 2mm proud of the carb body and drilling it out.
For obvious reasons I am very nervous of doing any damage to the carb body, so would appreciate an expert opinion about my proposed course of action.
The pin I'm talking about is the one next to the screw driver in the pic.
I am assuming it is a straight press fit item so intend cutting it off 2mm proud of the carb body and drilling it out.
For obvious reasons I am very nervous of doing any damage to the carb body, so would appreciate an expert opinion about my proposed course of action.
The pin I'm talking about is the one next to the screw driver in the pic.