23-10-2018, 08:21 AM
I'm having difficulties with my front pipe joint sleeve on a non-standard item (not sleevey enough to give strength to avoid an extra hanger point where it goes through SWB front cross member; its also a bit large in diameter and close to edges of hole)... but I do have a LWB front pipe here.
Is the issue with pattern LWB front pipe that it must go underneath the front chassis rail, thus has a different angle from the manifold and could never go through the SWB chassis 'ole?
Is the issue with pattern LWB front pipe that it must go underneath the front chassis rail, thus has a different angle from the manifold and could never go through the SWB chassis 'ole?