The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.32 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval



Austinsevenfriends › Austin Seven Friends Forum › Forum chat... v
Port polishing

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Port polishing
Tiger Offline
Senior Member
****
Joined: Apr 2018 Posts: 509 Threads: 129
Reputation: 2
Location: Staffordshire
Car type: Ruby mk 2
#1
14-10-2018, 03:19 PM
As some of you will remember my Ruby,s engine was loosely assembled when I acquired her.
The valve timing gears are one tooth out when looking at the dots.
Am I correct re-timing one dot in the middle of the two dots ?

Also any point in polishing the ports while access is easy ?
Regards
            Tim
Reply


Messages In This Thread
Port polishing - by Tiger - 14-10-2018, 03:19 PM
RE: Port polishing - by Alan - 14-10-2018, 04:17 PM
RE: Port polishing - by Dave Wortley - 14-10-2018, 04:46 PM
RE: Port polishing - by Chris KC - 14-10-2018, 04:53 PM
RE: Port polishing - by Tiger - 14-10-2018, 05:11 PM
RE: Port polishing - by Chris KC - 14-10-2018, 06:29 PM
RE: Port polishing - by Ian Williams - 14-10-2018, 08:21 PM
RE: Port polishing - by Alan - 14-10-2018, 08:30 PM
RE: Port polishing - by Ian Williams - 14-10-2018, 08:32 PM
RE: Port polishing - by Ian Williams - 14-10-2018, 08:43 PM
RE: Port polishing - by Chris KC - 14-10-2018, 09:11 PM
RE: Port polishing - by Ian Williams - 15-10-2018, 05:46 AM
RE: Port polishing - by Tiger - 15-10-2018, 08:22 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)