The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cross-shaft bearings: how much clearance is OK?
#2
I don’t have the answer but the centre and rhs are pulled forward, the lhs back. Adjusting the brakes with the footbrake somehow applied would seem to sort much of the lost motion. Mechanical perfection is satisfying but not always critical! I would not contemplate reducing any tubes over length.
I dunno how experienced you are but the (intended) concentric operation of the rhs tubes is far from obvious, is mentioned in few or no publications, escapes most, and is likely seized. Was eventually covered at length on the old site
Reply


Messages In This Thread
RE: Cross-shaft bearings: how much clearance is OK? - by Bob Culver - 27-09-2018, 08:02 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)