26-09-2018, 07:40 PM
Lots of things to try tonight after work. Thanks for the drawing Terry, that was what I had in mind for the puller idea. The flat piece would have a threaded hole in it. I will make it and try the drift idea first. I did think about just trying to whack it out then taking off any damage to the end too. The shaft has a flat on it on the part that goes inside the bush. The flat stops 3/8ths or so before the end of the bush. I imagine a little off the end isn't going to hurt.
When you fit the altered ratio gears what do you actually change. As this box is all apart is it work waiting till I can get those since it will only all have to come apart again. Does the lay shaft need to come apart anyway?
Simon
When you fit the altered ratio gears what do you actually change. As this box is all apart is it work waiting till I can get those since it will only all have to come apart again. Does the lay shaft need to come apart anyway?
Simon