The following warnings occurred:
Warning [2] Undefined variable $search_thread - Line: 60 - File: showthread.php(1617) : eval()'d code PHP 8.1.31 (Linux)
File Line Function
/inc/class_error.php 153 errorHandler->error
/showthread.php(1617) : eval()'d code 60 errorHandler->error_callback
/showthread.php 1617 eval




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Conrod removal
#6
Getting at it from below with the rod on the crank won't work because the piston has to be rocked right over to get at the bolt. However there might just enough clearance to get at the little end clamp bolt if the big end is undone, the head removed with the piston pushed out of the top of the bore. However holding the rod firmly enough might be impossible.
Has anyone tried this?
Probably a block removal job.
Jim
Reply


Messages In This Thread
Conrod removal - by fatcatvera - 19-09-2018, 10:05 PM
RE: Conrod removal - by Ruairidh Dunford - 19-09-2018, 10:09 PM
RE: Conrod removal - by fatcatvera - 20-09-2018, 09:40 AM
RE: Conrod removal - by Stuart Giles - 20-09-2018, 10:42 AM
RE: Conrod removal - by fatcatvera - 20-09-2018, 11:07 AM
RE: Conrod removal - by Robert Leigh - 21-09-2018, 10:24 AM
RE: Conrod removal - by AustinWood - 20-09-2018, 12:07 PM
RE: Conrod removal - by rubyman - 20-09-2018, 04:10 PM
RE: Conrod removal - by John Mason - 20-09-2018, 04:26 PM
RE: Conrod removal - by "Slack Alice" Simon - 20-09-2018, 06:26 PM
RE: Conrod removal - by Chris Garner - 20-09-2018, 09:37 PM
RE: Conrod removal - by Zetomagneto - 20-09-2018, 09:50 PM
RE: Conrod removal - by David Witton - 20-09-2018, 10:21 PM
RE: Conrod removal - by fatcatvera - 21-09-2018, 08:17 AM
RE: Conrod removal - by Chris Garner - 21-09-2018, 09:22 AM
RE: Conrod removal - by Zetomagneto - 21-09-2018, 11:42 AM
RE: Conrod removal - by John Mason - 21-09-2018, 06:06 PM
RE: Conrod removal - by "Slack Alice" Simon - 21-09-2018, 08:25 PM
RE: Conrod removal - by fatcatvera - 29-09-2018, 07:46 PM
RE: Conrod removal - by Ruairidh Dunford - 29-09-2018, 08:11 PM

Forum Jump:


Users browsing this thread: 8 Guest(s)