06-09-2018, 09:06 AM
(06-09-2018, 08:55 AM)Speedex750 Wrote: Also the same fixing for Opal door side screens and probably later tourer's. Mine, although tightened, don't seem to have any nip on the pegs - the less than perfect alignment of the two pegs stops them rattling about. There was the remains of a rubber washer between the screw and cup washer, perhaps the original way of stopping loose screws falling out?All helpful stuff! Thanks.
Dave
To me that sounds likely. A rubber washer pushed over the threads would "do a job" I was thinking about a "C" clip or similar, but a rubber ring sounds easier! There are a lot of cup washers around, not with that profile & some that are solid, but something will turn up. Point taken about the penny slot 1/10" (?) what is the head diameter of the screw?
I am still wondering how to fit the trim panel. Many of the pictures don't seem to show any form of external mechanical device!
David