11-08-2018, 04:49 PM
The carb bowl just sits there, usually nothing spills out if the needle valve above the float is in good condition.
Even with new washers the petrol unions often leak.
The temptation is to keep tightening the joints. Don't over do this. I always use the lowest grade Loctite as a sealant, it works nearly every time. "Screw" grade or something like that, not "stud" or "bearing fit" grades.
Simon
Even with new washers the petrol unions often leak.
The temptation is to keep tightening the joints. Don't over do this. I always use the lowest grade Loctite as a sealant, it works nearly every time. "Screw" grade or something like that, not "stud" or "bearing fit" grades.
Simon