28-07-2018, 11:34 PM
Woodrow has some useful plans for various simple to make tools flywheel puller an so on.
Here are a couple of head lifters 14 mm and 18 mm or even lift out the engine with them very simple to make just remove the center of the plug by removing the the lip securing the ceramic bit and gentle tapping it out, if you use an 18 mm split plug the job is half done for you, then remove the little bit the spark jumps to on the bottom, drill out the hole to 8.6mm and tap to 10mm then screw in a 10mm Hilti eye bolt. I also drilled a hole though the center of a M10 bolt, this can be used to find TDC on some makes of engine.
head lifters.jpg (Size: 52.2 KB / Downloads: 591)
Here are a couple of head lifters 14 mm and 18 mm or even lift out the engine with them very simple to make just remove the center of the plug by removing the the lip securing the ceramic bit and gentle tapping it out, if you use an 18 mm split plug the job is half done for you, then remove the little bit the spark jumps to on the bottom, drill out the hole to 8.6mm and tap to 10mm then screw in a 10mm Hilti eye bolt. I also drilled a hole though the center of a M10 bolt, this can be used to find TDC on some makes of engine.
head lifters.jpg (Size: 52.2 KB / Downloads: 591)