19-07-2018, 06:42 PM
The tool I use for this job is not to complicated.
A cam follower. the first washer was ground down to just under the bronze guides hole size. And the cam follower was SHORTEND with an angle grinder. So you don't have to remove the valve guide.
I use a bar thin enough to go down the valve guide as a drift. To remove the follower guide. And the same tool with a good hammer to refit the follower guides.
It's never failed.
I didn't even use a good follower, yes that's a crack down one side.
Priceless.
Tony.
[attachment=3292]
A cam follower. the first washer was ground down to just under the bronze guides hole size. And the cam follower was SHORTEND with an angle grinder. So you don't have to remove the valve guide.
I use a bar thin enough to go down the valve guide as a drift. To remove the follower guide. And the same tool with a good hammer to refit the follower guides.
It's never failed.
I didn't even use a good follower, yes that's a crack down one side.
Priceless.
Tony.
[attachment=3292]