04-09-2017, 04:00 PM
(This post was last modified: 04-09-2017, 04:00 PM by Hedd_Jones.)
I best not tell you that I run with gaps on my little ends. Gaps between the brasses that is.
This is on my traction engine. Adjusted by 'feel' with a threaded taper wedge.
It takes about a minute to adjust one if its clomping.
No spring washers, just a locking nut done up 'FT'
This is on my traction engine. Adjusted by 'feel' with a threaded taper wedge.
It takes about a minute to adjust one if its clomping.
No spring washers, just a locking nut done up 'FT'