13-06-2018, 05:10 PM
(13-06-2018, 03:14 PM)Ruairidh Dunford Wrote: No, the holes are different.
Measure the height of the spline and compare it with the depth of the input to the gearbox. There are several lengths of splines and fitting too long a one with prevent it disengaging.
Also check that the centre plate is not bottoming on/touching the flywheel nut lockwasher,
Thanks Ruairidh,
The center plate shows no sign of touching the lock washer and the spline seems right as it slides fully home. I haven’t changed anything apart from fitting new linings. Although not perfect it was better before when the linings were well used.
I’m now wondering if I should look at the toggle levers and how to measure?
Charles