12-06-2018, 09:33 PM
I have a 4 speed crash box that leaks at both ends,has anyone fitted lip seals and was it successful.
The Cornwall A7 site shows the output,but the crash box has a step in the casting a small seal would be needed.A thrower could be fitted between the speedo gear and output flange with a little machining to the inside does anyone have any thoughts.
On the input end it is fairly straight forward but i would use a larger diameter than the CA7c advises to suit the casting.On this end a V ring thrower could be used inside and a sealed LJ35 bearing with the internal seal removed again any thoughts or ideas appreciated.
Andy
The Cornwall A7 site shows the output,but the crash box has a step in the casting a small seal would be needed.A thrower could be fitted between the speedo gear and output flange with a little machining to the inside does anyone have any thoughts.
On the input end it is fairly straight forward but i would use a larger diameter than the CA7c advises to suit the casting.On this end a V ring thrower could be used inside and a sealed LJ35 bearing with the internal seal removed again any thoughts or ideas appreciated.
Andy