02-09-2017, 01:22 PM
(02-09-2017, 10:16 AM)Ian Williams Wrote: [attachment=573]Chris,
The D Moulding on the seats in my possession are constructed slightly differently to your description and were attached independently to the leather after the seat had been finished. The moulding is built up around a steel strip with pins at 2" intervals, first a strip of heavy canvas is folded in half and then in half again, the pin strip is then pushed through with a second strip of canvas below, this second strip is folded back over the top of the pin strip and finally a strip or Rexine folded back over the complete assy. Hopefully the following pictures will make my attempted description clear!
Pictures 1 & 2 show the Rexine cover striped back
Pictures 2 & 3 show the build up of folded canvas interior
Picture 5 shows the internal steel strip with pins spot welded to it.
That's interesting, mine are quite different. In the spirit of 'I'll show you mine if you show me yours' I'll attempt to post my first photo (sorry not as clear as yours Ian but the bead is staying in place for now).