02-06-2018, 08:10 PM
(This post was last modified: 02-06-2018, 08:17 PM by Colin Wilks.)
Apologies if I am taking this thread off at a tangent, but I have a sports crankcase into which I intend fitting a modified standard camshaft (the sports cam I have does not have sufficient meat on it to modify without building up with weld, plus I'm loathe to alter an original sports cam). I had planned to simply replace the bush in the crankcase with one to fit the smaller roller bearings of the standard camshaft. Am I missing a trick?
Also, I note Terrytuned's camshaft has no oil thrower on it. The oil thrower makes fitting the tab washer a pain. Do people usually just dispense with these?
Also, I note Terrytuned's camshaft has no oil thrower on it. The oil thrower makes fitting the tab washer a pain. Do people usually just dispense with these?