02-06-2018, 02:50 PM
Having ad no interest whatsoever in this topic, I decided to see how the gears meshed on the engine I have been reviving to power the speedex until I find a stash to get a nice engine for it. They were pretty sloppy before I sorted the camshaft end float, so I was surprised to find they are very tight now. This, I read, is not good... On reassembly, the faces of both gears are flush, so I didn't expect to have to take anything off the back of the crank one.
Do any of you clever folk know if doing so would solve the tightness or should I too be looking for new gears?
Do any of you clever folk know if doing so would solve the tightness or should I too be looking for new gears?