23-05-2018, 09:44 PM
(This post was last modified: 24-05-2018, 12:03 AM by John Newell.)
Hi all
I'm at that point in my engine rebuild where I need to torque up the starter dog bolt and the flywheel nut.
Tomorrow I will be tightening up the big end bolts
I'm using a Phoenix pressure fed crank, and Renault 4 rods.
Can anyone please help me with the required torque settings for these fasteners?
Google has suggested between 25 and 30 ft-lbs for the rods.
Phoenix has come back saying he thinks 100 ft-lbs may be correct for the flywheel nut.
I have no answers for the starter dog bolt, nor any idea if the above figures are correct.
Its been a while since I have been A7 Friends and its great to see the more modern forum bulletin board in use.
Looking forward to some informed replies
Regards
John
Christchurch
New Zealand
I'm at that point in my engine rebuild where I need to torque up the starter dog bolt and the flywheel nut.
Tomorrow I will be tightening up the big end bolts
I'm using a Phoenix pressure fed crank, and Renault 4 rods.
Can anyone please help me with the required torque settings for these fasteners?
Google has suggested between 25 and 30 ft-lbs for the rods.
Phoenix has come back saying he thinks 100 ft-lbs may be correct for the flywheel nut.
I have no answers for the starter dog bolt, nor any idea if the above figures are correct.
Its been a while since I have been A7 Friends and its great to see the more modern forum bulletin board in use.
Looking forward to some informed replies
Regards
John
Christchurch
New Zealand