23-05-2018, 02:49 PM
(23-05-2018, 01:21 PM)David. H Wrote: An entirely different topic...my later engine has the starter motor under the bonnet & the two 1/4 BSW nuts holding it on are so tight against the starter motor casing that I can only just get a short open ended spanner on the flats & then cannot get enough purchase to loosen them! Neither ring nor tubular spanners will fit in the space!
David
Had to chuckle - spent a good chunk of last night doing this very thing. I got by with sheer pereseverance.... plus taking other bits off to make access (don't forget turning the steering will move the drag link). Then nudge it round half a flat at a time...