21-05-2018, 08:46 PM
Dear Austin 7 Club Member,
It has come to our attention that some customers have experienced what appears to be excessive wear on the Camshaft gear after fitting our A7 Dynamator.
We believe that this is be due to our new gear not meshing correctly with the original old gear on the car .
We would advise customers to remove the unit and replace the front gear with their original gear .
It was our intention to supply a complete ready to bolt on unit but it appears this may not be possible at present .
If an original gear is not available then the new gear can be used but should be checked for wear at regular intervals .
We are currently looking at the possibility of making a new gear or a matched set but cost may be prohibitive and may be some time away .
We will advise of any future developments
Sorry for any inconvenience caused .
Regards
Tony Ibbotson
AccuSpark MD
It has come to our attention that some customers have experienced what appears to be excessive wear on the Camshaft gear after fitting our A7 Dynamator.
We believe that this is be due to our new gear not meshing correctly with the original old gear on the car .
We would advise customers to remove the unit and replace the front gear with their original gear .
It was our intention to supply a complete ready to bolt on unit but it appears this may not be possible at present .
If an original gear is not available then the new gear can be used but should be checked for wear at regular intervals .
We are currently looking at the possibility of making a new gear or a matched set but cost may be prohibitive and may be some time away .
We will advise of any future developments
Sorry for any inconvenience caused .
Regards
Tony Ibbotson
AccuSpark MD