02-10-2024, 02:26 PM
Just as a follow up and clarification I have attached a couple of photos. It looks to me as though my stator tube sticks out at the bottom by the amount it should stick out at the top (as the protruding part looks to be about the same length as the thickness of the Control Bracket (BM128)). Presumably it should sit flush with the bottom of BM47?
I will drill out the staking as suggested and see how the tube has been fitted.
The parts book doesn't show anything between the bottom bush (BM47) and the levers (BM143/59) - presumably there is no washer because the levers are bronze/brass and are adjacent to a bronze/brass bush?
I will drill out the staking as suggested and see how the tube has been fitted.
The parts book doesn't show anything between the bottom bush (BM47) and the levers (BM143/59) - presumably there is no washer because the levers are bronze/brass and are adjacent to a bronze/brass bush?