28-08-2024, 02:32 PM
(This post was last modified: 28-08-2024, 02:48 PM by Andy Bennett.)
Oh bugger, no I didn't do that R. I don't know why as I have seen others comment on it enough in relation to having blocks skimmed and adding spacers if required if pistons are too high but just didn't translate the same logic to the valves/head. I looked at the new one and thought about the depth, but why I didn't put it on the block and turn it over I don't know.
I guess there is nothing I can do now but turn it over by hand but guess I am not going to hear/feel anything and any problems will now show as bent valves and then compression variances/problems, bugger....
I guess there is nothing I can do now but turn it over by hand but guess I am not going to hear/feel anything and any problems will now show as bent valves and then compression variances/problems, bugger....
Enjoy yourself, it's later than you think!