23-08-2024, 09:02 PM
Fit a 3/8 whit helicoil in the crankcase ,chop the centre main bolt to length required and thread 3/8 bsw.
Ideally the top of studs flange should be level with crankcase or you may distort the block[shim if necessary]
Loctite stud into crankcase
i also have a stud in the valve chest[Dave Dye modified mine]
No mods to cam bearing oil supply .
Its been like this for decades.
Ideally the top of studs flange should be level with crankcase or you may distort the block[shim if necessary]
Loctite stud into crankcase
i also have a stud in the valve chest[Dave Dye modified mine]
No mods to cam bearing oil supply .
Its been like this for decades.