22-07-2024, 08:35 AM
(This post was last modified: 22-07-2024, 08:38 AM by David Stepney.)
The cables should be sufficiently taut so as not to cause the brakes to bind when the pedal and the handbrake are both off. The way I set the brakes is to then apply the handbrake two notches on and set the front brake cable so that the front brakes are just binding. Pull the handbrake on one further notch and set the rear brakes so that they are just binding equally. Any further adjustment can be done on the wing nuts on the handbrake and brake pedal. The brakes should be fully applied when the handbrake is pulled on four to five notches.
Sorry, I forgot you have Semi Girling brakes. Adjust the brakes on the adjusters on the back plates and then set the cable tension as described in my previous post.
Sorry, I forgot you have Semi Girling brakes. Adjust the brakes on the adjusters on the back plates and then set the cable tension as described in my previous post.