10-07-2024, 07:46 PM
Hi Jon
I’ve used very fine drill bits to clean and increase jet sizes. I believe the compensating jet (which I think is the one you are referring to) should be a 75 (0.75mm). You need a Dremel with a very small collet chuck to hold the drill bit. I prefer to gently hold it between thumb and finger.
Regarding a filter, I’ve never seen one here, only on the fuel intake to the float chamber.
Cheers
Howard
I’ve used very fine drill bits to clean and increase jet sizes. I believe the compensating jet (which I think is the one you are referring to) should be a 75 (0.75mm). You need a Dremel with a very small collet chuck to hold the drill bit. I prefer to gently hold it between thumb and finger.
Regarding a filter, I’ve never seen one here, only on the fuel intake to the float chamber.
Cheers
Howard