06-07-2024, 02:02 PM
Engine out and stripped down to replace piston rings, flywheel removed etc and rebuilt. Crankshaft and camshaft not touched.
All ancilleries removed and cleaned etc.
Timing is only set by eye at present using TDC as guide (1" before).
Have not checked actual compression but can feel it.
Carb stripped and cleaned and there is fuel in bowl.
Stupid question but could I have set the tappets 180 deg out?
All ancilleries removed and cleaned etc.
Timing is only set by eye at present using TDC as guide (1" before).
Have not checked actual compression but can feel it.
Carb stripped and cleaned and there is fuel in bowl.
Stupid question but could I have set the tappets 180 deg out?