21-06-2024, 07:57 PM
Sorry to hear you had problems Hugh, is there great difference between a Ruby and earlier models’ rear window seals…??
I really had no issues fitting Ruby’s rear window at all, I had far worse issues in other areas.
Fitted the seal around the glass pane first and as said previously making sure it was a good fit with no looseness and superglued the ends together so it was all self supporting. I then fed thin twine around the outer seal with the twine ends falling out at the bottom in the centre.
Light coating of washing up liquid on the outer surfaces, the showed wifey where to hold the glass and then pulling the twine out from the bottom and wifey applying pressure it went in ok, yes a bit of jiggery pockery, but it went in relatively easily.
The internal frame had been pre-drilled and whilst wifey continued to hold the unit in place I was able to fit screws to make sure it all stayed in place.
I really had no issues fitting Ruby’s rear window at all, I had far worse issues in other areas.
Fitted the seal around the glass pane first and as said previously making sure it was a good fit with no looseness and superglued the ends together so it was all self supporting. I then fed thin twine around the outer seal with the twine ends falling out at the bottom in the centre.
Light coating of washing up liquid on the outer surfaces, the showed wifey where to hold the glass and then pulling the twine out from the bottom and wifey applying pressure it went in ok, yes a bit of jiggery pockery, but it went in relatively easily.
The internal frame had been pre-drilled and whilst wifey continued to hold the unit in place I was able to fit screws to make sure it all stayed in place.