I have now removed the rods and measured them on the jig shown.
The difference between each side of the pin is:
1- less than 0.5tho
2- 7 to 8 tho
3- 4 to 5 tho
4 - 6 to 7 tho
I believe the issue is with the white metal but any suggested ways to resolve this issue would be welcome. The current suggestion is new little end bushes bored to suit the white metal
The difference between each side of the pin is:
1- less than 0.5tho
2- 7 to 8 tho
3- 4 to 5 tho
4 - 6 to 7 tho
I believe the issue is with the white metal but any suggested ways to resolve this issue would be welcome. The current suggestion is new little end bushes bored to suit the white metal