06-05-2024, 12:30 PM
I run a ball race in the rear bearing of my engine, but that's in conjunction with a very carefully fitted flywheel.
The objective is to retain the axial movement of the crank at the rear bearing, not the front lip. However, the grinding of the spacer that goes between the flywheel and bearing is a job where a couple of thou is important. It's a Frank Hernandez suggested mod.
Charles
The objective is to retain the axial movement of the crank at the rear bearing, not the front lip. However, the grinding of the spacer that goes between the flywheel and bearing is a job where a couple of thou is important. It's a Frank Hernandez suggested mod.
Charles