(21-04-2024, 07:36 AM)Reckless Rat Wrote: Perhaps the cotter pins securing the levers need turning round. ( from front to back)
The cotter nuts should be to the front.
Drat, I meant to attach a photo and obviously forgot. Anyway here it is to illustrate what I said. The actuator arm is not symmetrical but has a "wave" in it. Is there a way in which the "wave" of the actuator arm should be facing? I know it is difficult to explain. This photo is of the left hand backing plate. Also, the straight-edge is a ruler stood on edge, through the centre of the hub, and the ball of the actuator is in line with the centre (despite the slight discrepancy in the photo).
So RR, if the cotter pin is to the front, does it change the actuator angle? Thanks.
(21-04-2024, 11:15 PM)Tony Press Wrote:(20-04-2024, 09:02 AM)falcott Wrote: For sealed bearings, replacements for the front hubs/axles, are they standard bearings? Does anyone have part numbers please? Thanks.
Rear Hub and Front hub inner sealed bearing:
RHP LJ 1 1/4 SRR
SKF RLS 10 2RS
Front Hub outer RHP LJ 3/4 SRR
SKF RLS 6 2RS
Tony.
These are imperial (inch series) bearings so old stock is recommended
Hi Tony,
I went into SAECOWilson today and came away with the bearings, part numbers as you've given above. One made by KSM and the other by JAF. I'm guessing they are exactly the same. I haven't fitted them as yet.
Cheers, Geoffrey