18-04-2024, 06:03 PM
When I bought "Alice" a few years ago she had a tailpipe that was straight as die and left the silencer box and went straight back under the axle and tank. It was not attached anywhere other than where it was clamped in the rear of the silencer. Tis was clearly not right, but to fair it worked.
A couple of years ago I purchased the rear ipe seen in the attached photos. It was billed as an RP exhaust I believe, which given my RN thinks it is an RP seemed to fit the need. I couldn't work out where it was supposed to attch to the car after it left the silencer. Eventually I fashioned a rubber mounting to hold the pipe up above the axle. THe tailpipe hangs down very low (see photos again)
Where have I gone wrong? Should the swans neck section tilt sideways at all? which would bring the end of the tailpipe higher?
Advice gratefully received as always.
Thanks
Dave
A couple of years ago I purchased the rear ipe seen in the attached photos. It was billed as an RP exhaust I believe, which given my RN thinks it is an RP seemed to fit the need. I couldn't work out where it was supposed to attch to the car after it left the silencer. Eventually I fashioned a rubber mounting to hold the pipe up above the axle. THe tailpipe hangs down very low (see photos again)
Where have I gone wrong? Should the swans neck section tilt sideways at all? which would bring the end of the tailpipe higher?
Advice gratefully received as always.
Thanks
Dave