06-04-2024, 09:39 AM
It is a delicate job and I would never use a hammer or anything else to 'drive' the cups in or out. As Jamie says, use a vice. I find that a selection of sockets from a socket set are useful to enable the vice to push the bearing cups.
Whether the finished job will be out of balance is always a concern. It's probable best to mark the yolks so they go back in their original positions rather an 180 degrees out.
Whether the finished job will be out of balance is always a concern. It's probable best to mark the yolks so they go back in their original positions rather an 180 degrees out.