05-04-2024, 05:32 PM
Hi
I was faced with exactly this task, probably caused by someone in the past trying to use a hub puller with a damaged thread. A small sharp file was used to begin with on a small area where the damage was worst, followed by a thread restorer (as above) with the appropriate TPI pitch. Although the latter are sometimes called files, the cutting action is slightly different.
I was faced with exactly this task, probably caused by someone in the past trying to use a hub puller with a damaged thread. A small sharp file was used to begin with on a small area where the damage was worst, followed by a thread restorer (as above) with the appropriate TPI pitch. Although the latter are sometimes called files, the cutting action is slightly different.